how-to-fix-windows-error-code-0xc0000428

WINDOWS ERROR CODE 0XC0000428

You might encounter the Windows Error code 0xc0000428 in these two scenarios:

  • When you are trying to update an operating system.
  • When Windows is unable to verify a file’s digital signature.

The above error message pops up on Windows 7, 8, 8.1, and 10 versions. There is a fat chance that this error happens because your PC has registry issues.

Reasons for the error code 0xc0000428

  • After a system update, your boot manager might become outdated. During your Windows installation, if anything goes wrong, you will face this error message.
  • When you make use of a boot disc that is older along with a newer version of the Windows operating system, you may face the same windows error code 0xc0000428.
  • Any damaged file installed during a software or hardware change on your PC might also be the cause of this error. There are chances that this newly installed file could be malicious.

Steps to fix the Windows error code 0xc0000428:

To resolve the 0xc0000428 error on your Windows PC, carry out the following instructions:

Manually updating your Boot Manager

  • Try to boot from your Windows installation disc.
  • Select the desired language, time, and other fields for which you have to enter data using your keyboard.
  • Now, click the Repair your computer option.
  • Choose your Windows installation drive. In most cases, it will be C:\. Click the Next option.
  • You will now find the System Recovery dialog box on the screen.
  • From the above-mentioned dialog box, select the command prompt.
  • Type in the command given below: Bcdboot C:\windows /s D:\ Note: In the above command, C:\windows is the Windows installation folder. And, D:\ is the active boot partition.
  • Do not forget to press the ENTER key after typing in the above-mentioned command.

Other Suitable Methods to fix the Windows error code 0xc0000428:

Rollback your driver that is currently updated

Use the Device Manager to rollback the earlier version of your driver that has been updated recently. For this action, follow these steps:

  • Right-click the device that you have updated recently.
  • In the Device Properties dialog box that is displayed, click the Drivers tab.
  • Under the Drivers tab, select the rollback driver option.

Disconnecting any newly connected hardware

In case you have recently installed a new hardware, disconnect it now. Then, reboot your PC.

Uninstalling any recently installed software

Any software that has been newly installed on your Windows computer might have copied the incompatible Dynamic Link Libraries files. These files would have been copied to your computer’s hard disk, causing the error code 0xc0000428 on your Windows computer.

Make sure you fix the Windows error code 0xc0000428 as early as possible. If left unattended for a long time, It might cause delays or system failures.

windows error code 0xc0000428